Duct centrifugal fan VENTS VKMts 315
Air flow 1540 m3/h
Pipe diameter 313 mm
Power supply parameters 1/230/50
Noise level 53 dBA
Air temperature range from -25⁰C to +45⁰C
Fan speed 2730 rpm
Fan power consumption 0.19 kW
Fan current 0.8 A
Weight 6 kg
Length/height/width 308/402/410 mm
ROUND DUCT FANS VENTS VKMC
APPLICATION
The Vents VKMts 315 fans are recommended for wall mounting in offices, pizzerias, office premises, cottages, etc. They are usually installed in supply and exhaust ventilation systems.
DESIGN
The body mainly consists of metal parts, covered with zinc on top, which allows for outdoor installation of the fan without corrosion. The fan can be mounted on an external wall in any position relative to the fan axis. It is possible to connect several fans in parallel, which for convenience can be combined with a single controller (smooth or step), which will allow you to control them together or separately. The controller body is plastic, the minimum speed value is set by a built-in resistor on the device board. The fuse protects the controller from overloads and can be replaced in the event of a failure directly in the mounting box. The basic connection rules are described in the connection instructions.
ENGINE
The single-phase motor with external rotor and upward-curved impeller can be automatically restarted thanks to the built-in thermal protection system. The impeller undergoes dynamic balancing on a special device, which, together with the installation of high-quality bearings, leads to a significant increase in the service life of the motor.
PECULIARITIES
The models of this series differ mainly in peak performance (195-1540 m3/h) and power consumption (from 60 to 185 kW). The noise level of the entire series is low, although there are models with additional noise insulation and virtually silent operation.
The designations in the model names are as follows:
B - engine with reduced noise level.
P - includes a power cord with a C1 connector.
